Annexin V-EGFP/PI Apoptosis Detection kit (KTA0005): EGFP Signal and Controls Compared

Choosing an apoptosis kit often comes down to two questions: will the fluorophore hold up across the read, and will the controls tell you whether a flat result is real?
The Annexin V-EGFP/PI Apoptosis Detection kit (KTA0005) pairs EGFP-labeled Annexin V with propidium iodide (PI). The page states it "allows the identification and quantitation of apoptotic cells by flow cytometry or fluorescence microscopy," with simultaneous staining discriminating intact, early apoptotic, and late apoptotic or necrotic cells.
EGFP Signal With Stated Photostability
The fluorophore is the first differentiator. The page lists "Better fluorescence intensity and photostability" among the kit's benefits.
EGFP is conjugated to Annexin V, which the background section describes as "a 35–36 kDa Ca2+-dependent phospholipid-binding protein that has a high affinity for PS." As phosphatidylserine moves to the outer leaflet during apoptosis, the tagged Annexin V marks those cells in green. PI, "a membrane-impermeant DNA-binding dye," is excluded by live and early apoptotic cells but stains necrotic and late apoptotic cells red. PI is excitable at 488, 532, or 546 nm, so the two readouts fit standard filter sets.
Standardized Controls, Including Two Inducers
Controls are built in rather than left to the user. The component list includes Apoptosis Inducer A and Apoptosis Inducer B alongside Annexin V Binding Buffer (5×), Annexin V-EGFP, and PI.
The page frames this as "Standardized. Exclude the uncertainty factor of the experiment with positive control." For a lab comparing treatment conditions, having the induction reference inside the kit means the staining panel can be judged without setting up a separate positive-control experiment each run.
One Kit, Two Readout Platforms
Both flow cytometry and fluorescence microscopy are supported by the same reagent set.
That matters because apoptosis work rarely stays on one instrument: a cytometry experiment gives the population statistics, while microscopy confirms the morphology. The page lists "Suitable for flow cytometry or fluorescence microscopy" as a direct benefit, so the same staining can carry across both without changing probe chemistry. Storage is specified as at least 12 months at -20°C from shipment, protected from light, with gel pack and blue ice shipping; pack sizes are 20T, 50T, and 100T.
A Cite Line Worth Checking
The product page reports six publications, spanning neuronal calcium signaling, ferroptosis radiosensitization in non-small cell lung cancer, triple-negative breast cancer, myocardial infarction, cervical cancer immunotherapy, and high-methionine diet models.
Those citations are evidence of use contexts rather than a claim of validated performance in each model. Treat them as starting points when deciding whether the assay fits your own sample type, and verify the method section of any paper that overlaps with your work.
| Feature | This Product | Conventional / typical approach |
|---|---|---|
| Fluorescent label | EGFP-conjugated Annexin V; page states better intensity and photostability | varies by fluorophore choice |
| Positive control | Apoptosis Inducer A and B supplied | often set up separately |
| Readout platforms | Flow cytometry or fluorescence microscopy | commonly optimized for one platform |
| Storage | At least 12 months at -20°C, protected from light | varies by reagent format |
| Available sizes | 20T, 50T, 100T | may offer fewer pack options |
If your priority is a bright, photostable green signal with induction controls already in the box, KTA0005 is worth a closer look on the product page — especially if you split readings between a cytometer and a microscope.
Reference: https://www.abbkine.com/product/annexin-v-egfp-pi-apoptosis-detection-kit-kta0005/
For research use only. Not for diagnostic or therapeutic use.